I think I saw a photo on the Romaclub site of a demountable pod on a non flatbed with the sides cut to fit over the wheel arches.
By cutting the piece out of the side for the wheel arches, would this reduce the strength of the demountable?
Presumably the pod would sit higher than on a flatbed - would this cause stability problems?
I have a pod taken from my old Honda Acty.
If this was possible, any suggestions of the make & type of vehicle that I could put the demountable on.
Many thanks
Jack
By cutting the piece out of the side for the wheel arches, would this reduce the strength of the demountable?
Presumably the pod would sit higher than on a flatbed - would this cause stability problems?
I have a pod taken from my old Honda Acty.
If this was possible, any suggestions of the make & type of vehicle that I could put the demountable on.
Many thanks
Jack
Comment